Measure the seat
Fix the upholstery surface on the cut wooden board
Mark foam
approx.: add 1-2 cm
Cut the foam with a try square
Place the seat and attach the foam in the middle
then cut off the corners
then fix from all sides with the stapler
Correct corners
Measure the length and width of the cover fabric
Cut the cover material slightly larger accordingly
Upholstery fabric with the bottom and with the fold the foam together
Mark the midpoints of the sides
Mark the centers of the fabric
Center to center on all 4 sides fix with the stapler
Carefully stretch and fix the corners
Cover material with tools if necessary again loosen and tighten
Lay the corners on top of each other and fix
Remove excess fabric and staple firmly
ensure good form and tension
Fold in the corners and secure
remove excess fabric and staple
finish all remaining corners
remove excess fabric
Measure floor area for covering material
mark and cut
Fold in the edges and fix in the middle
fold in all corners and fix well
finally close tightly with the stapler
control look
and done!